Corghi R.E.M.O. COMPACT Manuel D'utilisation page 74

- Wait for the data to be saved.
- Return the wheels to the straight position.
allows execution or abortion of the
maximum steering lock procedure, selection of
which is displayed in the status bar by the
symbol. After the angles at 20° are
saved, turn the steering wheel as far as it will
go and wait for the signal that the values have
been saved.
(9) Data summary
Once the steering lock procedure is complete,
the system automatically moves on to display of
all the data measured. This function can other-
wise be accessed by selecting the
or the F5 key.
If the databank reference values are available,
the values are displayed:
on a red background if they are outside the
tolerance range
on a green background if they are inside the range
on a black background if there are no reference
values.
The icons highlighted alongside a measured
value carry the following meanings:
indicates that the angle is ad-
justable.
indicates that a help function
is available for the adjustment.
The stylised vehicle illustrates, in an accentuated
way, the half toe, camber and setback situation.
saves the vehicle's pre-adjustment
values. The icon is only active if saving is set in
"Manual" mode in the set-up.
(10) Rear axle measurement
To access this function from the rest of the pro-
gramme select the
Level the targets and adjust the angles by
bringing the values within the tolerance range
(numerical data and graph bar coloured green).
Selecting the
measurement screen toggles between the two
pages of values.
74
icon
icon or the F2 key.
icon from the rear axle
cyclically displays only one value pair
at a time. In this phase, the angle symbol shows
the real situation of the car
(11) Front axle measurement
To access this function from the rest of the pro-
gramme select the
Level the targets and adjust the angles by
bringing the values within the tolerance range
(numerical data and graph bar coloured green).
The 2 front axle measurement screens display
the front caster, front camber, front half toe, front
total toe and front set-back angle values.
On the front axle measurement screen, the
icon switches alternately between the
two pages of values.
cyclically displays only one value pair
at a time. In this phase, the angle symbol shows
the real situation of the car.
normal display mode.
For adjustment of the caster the data, only avail-
able if the steering lock measurement procedure
has been carried out, must be on the screen.
The data are only shown when the front targets
are levelled.
N.B. On exit from this procedure the caster values
are saved automatically.
Saving of these values means that the procedure
can always be restarted from the last adjust-
ment made.
If a new steering lock procedure is performed, the
values recalled will be the last ones measured
during the steering lock sequence.
(12) Second angle measurement
with steering locked
Repetition of the steering axis angle measure-
ment allows you to check whether errors have
been introduced during adjustment of the caster.
The procedure is exactly the same as the first time
the caster, king pin and steering angle difference
values were measured.
Operator's manual R.E.M.O. COMPACT
.
icon or the F1 key.
returns to