Electrical Hook-Up - Corghi EM 9380 XLine Manuel D'utilisation

(A) Automatic diameter and distance measuring arm
B) Automatic ultrasonic sensor for measuring the width (optional)
(C) Head
(D) LCD monitor
(E) Control keypad
(F) Side flange holder
(G) Weight tray
(H) Wheel support shaft
(I) Anvil
(J) Wheel guard
(L) Cone holder
(M) Control pedals C
On request, the wheel balancer can be set up by the manufacturer to operate with the
power supply available in the place of installation. The set-up data for each machine are
given on the machine data plate and on a special label attached to the power supply
connection cable.
CAUTION
Any operations for hooking up to the workshop electrical board must be carried out
only by qualified technicians in compliance with the regulations in force, under the
responsibility and at the charge of the customer.
86
Main working parts (Fig. 8)

ELECTRICAL HOOK-UP

Operator's Manual EM 9380 XLine - EM 9380C XLine
8