Publicité
SilverCrest SIKP 2200 B2
7. Getting started
7.1 Setup and connection
Place the appliance on an even, non-slip and dry surface.
Risk of fire!
Do not place the appliance on textile surfaces such as tablecloths.
Do not place the appliance on metal surfaces. These can heat up quickly and cause a
fire.
Never place the appliance under flammable items such as curtains.
The openings on the bottom of the product must never be covered. Keep a distance of at
least 10 cm clear all around the appliance and at least 60 cm clear above it to
guarantee sufficient cooling.
7.2 Usage
If you switch the induction hotplate off and the surface temperature of the heating zone
(2) is higher than 60 °C, "– H –" is shown on the display. If the temperature drops
below 60 °C, the display shows "– L –".
If you remove the pan from the induction hotplate when in use, the display shows "E0"
and a beeper sounds every 2 seconds. After around 60 seconds, the beeper stops and
the fan switches off. The display (11) continues to show "– H –" for as long as the
surface temperature of the heating zone (2) is greater than 60 °C. If the temperature
drops below 60 °C, the display (11) shows "– L –".
The only way to hide the "– H –" and "– L –" symbols from the display (11) is by
disconnecting the product from the mains.
When the induction hotplate is switched on, the preset power level is L05.
1.
Connect the induction hotplate to a live mains socket using the power cable (1). A beeper then
sounds and the display (11) shows "– L –" or "– H –" depending on the temperature.
2.
Place a pan on the hotplate (2).
62 - English
Publicité
