Stryker Power-PRO IT Cot Mode D'emploi page 55

I I t t e e m m
Electronic controls
Switches
Litter
Base
Wheels
Head section
E E v v e e r r y y 1 1 2 2 m m o o n n t t h h s s o o r r 2 2 4 4 h h o o u u r r s s
Inspect these items every 12 months or 24 hours, whichever comes first.
I I t t e e m m
Settings
Cylinder
Manual backup release handle
Litter
Base
Wheels
6516-209-005 Rev AA.0
I I n n s s p p e e c c t t
Extend cot to raised position, measure and check load
height
Jog function operates
High speed retract works
No damage or wear to either switch
Both switches operate
No bent, broken, or damaged components
No damage or tears on cot grips
No bent, broken, or damaged components
Cot retaining post is secure. If not, replace the screw
No excessive damage to X-frame guards
Free of debris
No bent, broken, or damaged components
Grip bar has no excessive damage or tears
Load wheels are secure and roll
I I n n s s p p e e c c t t
Cot and fastener fit and function
Safety bar connects to the vehicle safety hook
Cylinder is adjusted - lock nut is tight and the cot stops
moving when it hits the dead stops
Returns to the stowed position
All welds are intact, not cracked, or broken
Warning labels present, legible
All welds are intact, not cracked, or broken
Check and adjust wheel locks
51 EN