Publicité
Les langues disponibles
Les langues disponibles
I I t t e e m m
Battery
Charger
E E v v e e r r y y t t h h r r e e e e m m o o n n t t h h s s o o r r s s i i x x h h o o u u r r s s
Inspect these items every three months or six hours, whichever comes first.
I I t t e e m m
Cylinder
Hydraulics
Cables and wires
Manual backup release handle
Litter
Base
X-frame
Head section
E E v v e e r r y y s s i i x x m m o o n n t t h h s s o o r r 1 1 2 2 h h o o u u r r s s
Inspect these items every six months or 12 hours, whichever comes first.
I I t t e e m m
Hydraulics
EN
50
I I n n s s p p e e c c t t
S S M M R R T T Pak housing and terminal area for cracks or
damage before first and every use
S S M M R R T T charger and parts for cuts in the cord, bent pins or
contacts, or cracks in the housing before first and every
use
I I n n s s p p e e c c t t
All fasteners are secure
No hydraulic fluid (red) leaks
Loose fittings - tighten, if needed
Motor mount fasteners are secure
No hydraulic fluid leaks
No leaks from reservoir
No damage or pinching of wiring harness, cable, or lines
No damaged connectors
Base extends and retracts when you pull the manual
backup release handle
Cot does not lower when you pull the manual backup
release handle with 100 lb (45 kg) or more on the cot
All fasteners are secure
Backrest cylinder operates
Adjust pneumatic cylinder for full range of motion, if
required
All fasteners are secure
X-frame expands and retracts
All fasteners are secure
Head section extends and locks
I I n n s s p p e e c c t t
Hoses and fittings for damage or wear
Hydraulic velocity fuse - place a weight of approximately 50
lb (23 kg) on the cot, raise the cot, lift the cot with two
operators, pull the manual backup release handle, rapidly
set the cot down, and make sure that the cot does not drop
6516-209-005 Rev AA.0
Publicité
