Publicité
Les langues disponibles
Les langues disponibles
Incubator adaptor
A A i i r r b b o o r r n n e e ™ side-by-side
D D r r a a g g e e r r ®
A A i i r r b b o o r r n n e e ™ stackable
No adaptor option (airsled or
equivalent configuration)
I I n n s s t t a a l l l l i i n n g g t t h h e e A A i i r r b b o o r r n n e e i i n n f f a a n n t t t t r r a a n n s s p p o o r r t t i i n n c c u u b b a a t t o o r r a a d d a a p p t t o o r r i i n n t t h h e e s s i i d d e e b b y y s s i i d d e e
c c o o n n f f i i g g u u r r a a t t i i o o n n
W W A A R R N N I I N N G G
• Do not install these incubator adaptors on any other Stryker cot or on any cot from another manufacturer. These
incubator adaptors are for use only on the P P o o w w e e r r - - P P R R O O IT cot.
• Always make sure that the incubator adaptor is properly installed on the cot and the incubator is securely fastened to the
incubator adaptor before use.
Before you install an incubator adaptor on the P P o o w w e e r r - - P P R R O O IT cot, read and understand this manual and the manual that
was supplied with the incubator adaptor.
To install the incubator adaptor (Figure 14):
1. Push down on the latch tab (A) to release the latch tab (B).
2. Pull down on the latch tab (B) and open each of the latches on the four corners of the incubator.
3. Place the A A i i r r b b o o r r n n e e ™ incubator into the incubator adaptor on the cot. Make sure that you place all four corners of the
incubator into the incubator adaptor.
4. Insert each latch into its slot on the incubator adaptor.
5. Push up the latch tab (B) to secure the latches.
6516-209-005 Rev AA.0
T T a a b b l l e e 1 1 – – I I n n c c u u b b a a t t o o r r a a d d a a p p t t o o r r a a n n d d r r e e q q u u i i r r e e d d t t o o o o l l s s f f o o r r i i n n s s t t a a l l l l a a t t i i o o n n
Required tools
•
5/32" Allen wrench
•
3/16" Allen wrench
•
1/2" socket and ratchet
•
5/32" Allen wrench
•
3/16" Allen wrench
•
1/2" socket and ratchet
•
1/2" socket and ratchet
Page
Installing the Airborne infant transport
incubator adaptor in the side by side
configuration (page 33)
Installing the Drager infant transport
incubator adaptor (page 34)
Installing the Airborne infant transport
incubator adaptor in the stackable
configuration (page 35)
Installing the no adaptor option airsled
transport incubator with a sled
receptacle (page 36)
33
EN
Publicité
