Orved Cuisson 31 Mode D'emploi Et D'entretien page 72

MAINTENANCE AND TEChNICAl SUPPORT
11) Use a hexagon wrench to undo the oil filling cap
12) Use the same wrench to undo the drain cap
out of the pump and directly down the slide into a container. Leave the oil to flow out for about ten minutes (Fig. 8).
13) Refasten the drain cap at the bottom of the pump and refill the pump with oil up to the correct level: in the sight-glass,
the level of oil should be near the top line (fig. 9).
14) Fasten the filling cap.
15) Put the slide back C
C
MAX
MIN
72
Rev. 01 - 03/2018 - Cod. 1500024 - Instruction manual for vacuum chamber packaging machines for vacuum cooking mod.
b
on the body and tighten the screw fastener.
A
b
A
at the top of the pump.
. Be careful because, as soon as the cap is removed, the oil will flow
fig. 9
Fig. 8
Cuisson