Installation - Orved Cuisson 31 Mode D'emploi Et D'entretien

INSTAllATION

7. INSTAllATION
Proceed by carefully following the sequence of points 1 to 9:
1) Unpack the machine (refer to Chap. 4)
ATTENTION!
• After having removed the packaging, check the integrity of the appliance. If in doubt, do not use the
machine and contact the dealer immediately.
• Never tilt or turn the machine over: always move it in the upright position. This prevents the oil leaking from the
vacuum pump.
• Only use man power with utmost care to move the machine.
2) Place the machine on a surface that is flat, stable and suitable for the load.
ATTENTION!
• In the case of Cuisson 41h and Cuisson 61 models, block the front wheels by lowering the pedals.
• The appliance must be positioned so as to be accessible from all sides.
• Do not obstruct passage-ways, escape or service routes with the machine. Do not position the appliance in front
of exits or emergency doors.
• Make sure the machine is ventilated properly, leaving a gap of about 10 cm around the entire appliance.
The ventilation slots must remain free and unobstructed in order to maintain the pump temperature at a normal
level.
3) Open the lid by lowering the lid-catch hook.
Mod. Cuisson 31
32
Rev. 01 - 03/2018 - Cod. 1500024 - Instruction manual for vacuum chamber packaging machines for vacuum cooking mod.
Mod. Cuisson 41h
Mod. Cuisson 41
Mod. Cuisson 61
Cuisson