Spinning The Wheel - John Bean b 9200 Manuel D'utilisation

1
44
5.3.2.5-1
5.3.3-1
Operation
5.3.2.5 Internal Balancing
Application of a patch inside a tyre.
To activate the procedure press key "F" (1) then the
"INT" (2) key, Figure 5.3.2.5-1. The left-hand display
shows the text " ", which means you must enter
the external tyre diameter which will be shown on the
right-hand display.
Note: The procedure is the same as for static balancing;
the only difference being that you need to enter the
external tyre diameter in order to calculate the weight.
5.3.3

Spinning the Wheel

Acquire the wheel data and proceed as follows:
• Activate the lever (1) - Fig. 5.3.3-1 to spin
the wheel.
Wheels must turn clockwise, seen from the side of the
unit on which they are mounted.
The operator must release the lever (1) once the rotation
speed is reached.
Any foreign object in contact with the lever or with the
wheel, after the wheel spin, will cause errors in
measuring the imbalances.
The measurement is completed as soon as the direction
indicators light up. The unit beeps. The brake will be
applied automatically.
The weight(s) to be applied will be shown on the display.
For higher precision, select Fine.
Operator's Manual b 9200