John Bean b 9200 Manuel D'utilisation page 18

1
3
4
5
6
9
8
18
2 1
3
4.1-1
7a
10 11 12 7b
4.1-2
Layout
4.1 The display
Refer to Figure 4.1-1.
1. Rotation indicators of the correction plane.
The indicators show the direction the operator has
to rotate the wheel (by hand) after a balancing run.
2. Weight Application Position (WAP) indicator.
The indicator will light up when the wheel is in the
correct position for weight application. This indicator
will be referred to as the WAP indicator.
Refer to the weight mode selected before applying
a weight!
3. Display.
Depending on the stage of the program the display
gives the operator information about rim sizes,
balancing weights, error codes, etc.
4. Weight units indicator, "Oz".
The indicator will light if the weight is displayed in
ounces instead of grams (default).
5. INT function.
This indicator lights up when the "INTERNAL"
balancing mode is selected.
6. Flange compensation.
This indicator lights up when flange compensation
is activated
7. Truck, Light-Truck and Car Mode Indicator.
This indicator lights up as follows depending on which
mode is active.
- Truck Mode: both LEDs are OFF .
- Light-Truck Mode: the 7a LED is ON.
- Car Mode: the 7b LED is ON.
8,12
Weight Position Indicator.
Apply a clip-on or stick-on weight to the rim at the
position indicated when the WAP indicator for this
plane lights up.
9,10,11
Weight Position Indicator.
Apply a stick-on weight to the rim at the position
indicated when the WAP indicator for this plane
lights up.
Operator's Manual b 9200