Weight Application - John Bean b 9200 Manuel D'utilisation

46
5.3.4-1
5.3.4-2
5.3.4-3
5.3.4-4
Operation
5.3.4

Weight application

The following weight types and application methods are
available:
- clip-on weights.
Always apply by hand.
- stick-on weights.
Must be applied by hand or with the gauge arm,
depending on the weight mode.
Note: Hand applied weights must always be applied
exactly perpendicular to the shaft (12 o'clock position).
After spinning the wheel (refer to Figure 5.3.4-1):
· Look at the rotation indicators for the left plane of
the wheel.
If one or more indicators are lit:
· Turn the wheel to find the application point.
As the correct angular position of the wheel is
approached the indicator will light.
When all indicators are lit, the position is correct, Figure
5.3.4-2.
Note: At the correct angular position all rotation
indicators will be lit. If the wheel has been rotated too
far, only the indicators for the other half will be lit. Refer
to Figure 5.3.4-3. The wheel has to be gently reversed.
The weight to be applied in that plane is shown on the
display.
• Turn the wheel manually until it reaches the
counterweight application point
Attaching a clip-on weight.
Refer to Figure 5.3.4-4.
• Clip-on weights must always be applied in the 12
o'clock position.
• The lip should rest on the rim edge. Use the weight
pliers to position it.
In STATIC mode only the left hand display is used.
Operator's Manual b 9200