John Bean b 9200 Manuel D'utilisation page 104

1
104
2
3
4
iii-1
Installation Instructions
iii Installation procedures
Wheel balancer:
Refer to the drawing in i for wheel balancer space for
movement and use. This is a mobile unit, whose
reliability is guaranteed whether or not it is secured to
the floor.
Main shaft wheel adaptor:
•
Before fitting the wheel adaptor, clean the main shaft
support cone and the internal adaptor cone carefully.
Fitting the wheel adaptor
Fig. iii-1
1 main shaft support cone.
2 wheel adaptor basic clamping adaptor.
3 Securing screws (hexagonal socket head CH14).
4 Hexagonal wrench (Allen key ) (included).
• Fit the wheel adaptor onto the main shaft support cone
so that the cylindrical headed screw at the end of the
cone is inserted in one of the slots on the basic
clamping adaptor.
• Fasten the wheel adaptor by tightening the securing
screw.
Appendix b 9200