Preparation; Emergency Stop - John Bean b 9200 Manuel D'utilisation

30
5.2.1-1
5.2.1-2
5.2.2-1
Operation

5.2 Preparation

• The operator should be familiar with the warnings
and cautions.
• The operator should be qualified to work with the
unit.
• Always ensure that the wheel guard is lifted and the
gauge arm is in its home position (far left position)
when the unit has been switched off.
5.2.1 Power up
See Figure 5.2.1-1.
If using the power adapter (standard)
• Plug the power output plug of the adapter into the
power socket of the balancer.
• Plug the adapter into the mains power outlet.
• Do not keep any key pressed, then activate the power
switch in the "AC ADAPTER" position.
Using the battery pack (optional)
• • • • • Insert the battery pack in the housing on back of the
balancer.
• Do not keep any key pressed, then activate the power
switch in the "BATTERY" position.
The unit will beep and perform a self check now.
All the indicators and displays will come on for a few
seconds so that the operator can check that they
are all working correctly.
At the end of the self check, the Motorcycle Wheels
Indicator is ON. This LED also acts as a Machine ON
warning light, since it only goes out when the unit is
switched off.
Note: If the unit beeps and does not proceed or
if an error code is shown, see Chapter 7.
Then the ignition indicator, the display and the weight
position in relation to wheel current type (default)
indicators will come on.
See Figure 5.2.1-2 for an example.
The unit is now ready to receive input.

5.2.2 Emergency stop

Refer to Figure 5.2.2-1.
To perform an emergency stop:
• • • • • Press the STOP key (1) to apply the electronic
brake.
1
In the event of an emergency stop due to an unexpected
action by the unit, rethink the steps that were
performed:
Operator's Manual b 9200