Table des Matières
Publicité
48
5.3.4-5
5.3.4-6
5.3.4-7
Operation
Attaching a stick-on weight.
ALU or STATIC weight modes only:
Refer to Figure 5.3.4-5.
•
Apply the weight on the rim in the 12 o'clock position at
the correct offset position.
•
The lit indicator on the display gives an indication of
the correct position.
Note:
With STATIC weight modes, always apply the
weight at the rim centre line. If not possible,
split the weights evenly and apply on another
surface of the rim (symmetrical to the rim
centre line).
Alu 2P and Alu 3P (HWM) weight modes:
Refer to Figure 5.3.4-6.
The gauge arm must be used to apply the stick-on
weight(s).
•
Place the stick-on weight on the gauge arm. Refer to
Figure 5.3.4-7.
•
Bring the gauge arm to the left plane reference point.
Note:
When the value "0" appears while moving
the arm, the machine beeps to indicate that
the correct application position has been
reached.
•
Apply the weight to the correct point on the rim.
•
Decide whether to use Split Weight Mode now (Chapter
5.4.1).
•
Rotate the wheel to the next WAP position, put the stick-
on weight on the gauge arm and apply the weight at
the right plane reference point.
Note:
When the internal gauge is removed, the
data is normally displayed, unless the left
plane has reached the angular position for
weight application and a stick-on weight
is used.
Or
The right plane has not reached the angular
position for weight application.
When this happens, the appropriate weight
and a variable number appear on the other
display to indicate the direction in which
the gauge arm must be moved in order to
find the correct weight application position.
Operator's Manual
b 9200
Publicité
Table des Matières
