Selecting The Operating Mode - John Bean b 9200 Manuel D'utilisation

5
72
6
1
2
4
5.6-1
5.6-2
Operation
5.6 Selecting the operating
mode
To use the balancer normally you do not need to change
the operating mode and the relative states set by the
manufacturer. In special cases, however, or if working
conditions require it, the operating modes and states
can be changed by entering the appropriate codes.
Operating mode settings and values
• Press F (1, Fig. 5.6-1) + C-Code (2) to enter the C-
Code mode.
3
• Use the + and - keys (3) e (4) to select the relevant
C-Code, displayed on the left indicator (5).Press the
C-Code to confirm.
• Use the + and - keys to select the relevant operating
state, displayed on the right indicator (6). Press the
C-Code to confirm and return to the base value - Fig.
5.6-2.
This changes the operating mode which is then saved
until a new setting is entered or until the machine is
turned OFF.
The operating modes that are changed in this way can
be saved permanently using the C10 code.
Now if the machine is turned OFF these modes are not
lost and every time the machine is turned ON they are
already set until they are changed again.
Note: Code C4. Clamping device compensation.
This code cannot be saved permanently.
The editing codes and the key combinations for entering
them are listed below.
Operator's Manual b 9200