Shutting Down - John Bean b 9200 Manuel D'utilisation

32
Operation
Did the operator make an error or omit to do
something?
Correct the input and continue working. No special
procedure is required.
Did the unit do something unexpected?
• Read the relevant chapters again.
• Prepare the unit for a restart:
switch off the unit
switch on the unit again.
• Carefully repeat the commands with the manual
available.
• If the unit does not function correctly, call the service
team immediately.
WARNING: PREVENT ANY FURTHER USE OF THE
UNIT.

5.2.3 Shutting down

Always shut down properly when work is complete:
• Remove the wheel from the balancer.
• Remove the cones and quick-release hub nut from
the stub shaft. Check the surfaces (internal and
external) of the cones for damage. The condition of
the cone is very important for a good balance quality.
• Check the thread of the hub nut and stub shaft.
• Clean all threads with a dry, soft cloth.
• Store the cones and the hub nut in the correct place.
• Unplug the mains cable from the power outlet.
• Check the power cable for damage or wear.
• Tidy up the storage areas.
• Clean the display and input panel with a soft, dry
cloth.
• Remove old wheel weights and other material from
under the balancer. The balancer must rest on its
three feet only.
5.2.4 Settings
After switching on the unit, a default weight mode is
shown. If the unit then shows another weight mode,
refer to Chapter 5.3.2.
The default unit of measurement indicated at power up
is grams and inches, but the unit saves the ounces
and/or millimetres setting selected before switch off in
the memory. To change, see 5.2.4.1 and 5.2.4.2.
Operator's Manual b 9200