Table des Matières
Publicité
6
11
3
2
5
13
20
7
9
4.2-1
Layout
4.2
The input panel
Refer to Figure 4.2-1.
1. Diameter key with indicator.
Press to select "rim diameter" mode, the current
diameter or "dia" value will appear and the unit will
beep.
The current value will be shown on the display and
can be edited.
10
2. Width key with indicator.
Press to select "rim width" mode, the
will appear, representing the width value and the unit
12
will beep.
The current value will be shown on the display and
can be edited.
8
3. Offset key with indicator.
Press to select "Offset" mode, the ---I indication and
1
current offset value will appear and the unit will beep.
4
4. + key.
To increase an input value (e.g. rim diameter, offset,
rim width).
Hold the key down to increase the values shown
automatically.
5. - key.
To decrease an input value (e.g. rim diameter, offset,
rim width).
Hold down the key to reduce the values shown
automatically.
6. Function key.
Activates the second function of multi-function keys
(indicated by the graphics on the lower section of
the keys). Press this key and F appears on the left
display then disappears when you press one of the
function keys. The F on the display also disappears
when you press the function key again (it is
sometimes used like enter).
7. Fine key.
Press to toggle the read-out accuracy between
Normal, or 25, 50 or 100 (0.5,1 or 2 oz) depending
on the registered value and Fine i.e. 10 grams
(0.5oz) regardless of the registered value. The unit
will beep. Release the key to return to normal
accuracy. F+Fine key activates the car wheel
optimisation and minimisation operation.
Operator's Manual
symbol
b 9200
Publicité
Table des Matières
