John Bean b 9200 Manuel D'utilisation page 84

84
Trouble shooting
7.0 Troubleshooting
If a problem arises with the wheel balancer, proceed in
the following order to solve the problem:
1. Rethink the last steps taken.
Did you work according to the manual?
Did the unit work as described and expected?
2. Check the unit according to the points listed in this
chapter.
3. Call your local sales agent for technical service.
The set up of this chapter is:
Problem
1. Possible cause #1
• Possible solution(s)
2. Possible cause #2
• Possible solution(s)
When switched on, nothing lights up.
1. Power switch in OFF position.
• Set power switch to
- AC ADAPTER for mains power supply through
transformer, or
- BATTERY for battery pack (optional) power supply.
2. No power supply connected
• Connect power lead or battery pack (optional) to
the unit.
3. No power supply
• Check power supply, power system fuses or the
(optional) battery charge.
4. Fuse(s) of the unit blown.
• Replace fuse(s) of the unit.
If the fuse(s) has (have) recently been replaced, call
service to check the unit.
When switched on, a beep is heard for 1 second.
Configuration error.
1.
• Call Service Team
When switched on, the unit beeps with a certain
sequence.
• Note down the sequence.
• Call Service Team
Display appears to freeze or lock up.
1. The unit may be in a program, waiting for a specific
action.
• Finish the program currently in use.
• Switch off the unit.
Wait for 20 seconds, switch on
the unit. Proceed.
Operator's Manual b 9200