Finding A Wire Break - Viking MI 632 Manuel D'utilisation

Installing the carrier plate:
Thoroughly clean the blade shaft (1) and
the mounting on the carrier plate (2). Push
the carrier plate as far as possible onto the
blade shaft.
● Install the mowing blade. (

16.7 Finding a wire break

In the event of a wire break, the red
LED on the docking station flashes.
( 13.1) A corresponding message
appears in the display of the robotic
mower.
If a wire break cannot be found as
described, contact your VIKING
specialist dealer.
The wire break search can be performed
either with the control panel removed or
inserted. The control panel should be
inserted for the fine search.
146
Remove the docking station cover and
disconnect the right perimeter wire
end (1).
The following instructions describe how to
search for a wire break in a clockwise
direction, i.e. the perimeter wire is followed
16.4)
in a clockwise direction starting at the
docking station. The search can also be
performed in an anti-clockwise direction if
necessary, however the left perimeter wire
end must then be disconnected.
● Press and hold the Home button
on the docking station,
simultaneously pressing the
ON/OFF button twice. The green
LED illuminates and the red LED
flashes. (
● Remove the control panel if necessary.
( 15.2)
● In the "Service" menu, select the "Find
wire break" entry and confirm OK.
( 11.17)
13.1)
Searching with control panel removed:
Starting at the docking station, follow the
edge of the mowing area clockwise with
the robotic mower (1). Steer the machine
using the control pad for this purpose and
ensure that the perimeter wire (2) runs
under the wire sensor. The wire sensors
are installed in a protected position on the
left and right at the front of the robotic
mower.
During the wire break search, the signal
strength is indicated in the display; the
wire sensors are in the ideal position
above the perimeter wire when this value
is at its highest.
The Wire signal OK symbol
appears in the display when the
wire sensors are correctly
receiving the wire signal.
In the area of the wire break, the
signal strength drops and the
Check wire signal symbol
appears in the display.
0478 131 9933 A - EN