Routing The Perimeter Wire - Viking MI 632 Manuel D'utilisation

Then press the OK button on the
control panel.
If the battery is discharged, a
plug symbol appears instead
of the battery symbol at the
top right corner of the display after
docking and the battery is charged
while the perimeter wire is being
routed. ( 15.8)

9.7 Routing the perimeter wire

Please read and observe the entire
"Perimeter wire" section before
performing wire routing. (
In particular, plan the routing,
observe the wire clearances and
install no-go areas, reserve wire,
linking sections, secondary
areas and corridors during wire
routing.
108
Fasten the perimeter wire (1) to the ground
12.)
on the left A or right B as appropriate,
next to the floor plate, directly next to a
wire outlet, using a fixing pin (2).
Provide a free wire end (1) with a length of
approx. 1 m.
Internal docking station:
Route the perimeter wire (2) in front of and
behind the docking station (1) for 0.6 m in
a straight line and at right angles to the
floor plate. Then follow the edge of the
mowing area with the perimeter wire.
If the offset drive home (passage) is
used, the perimeter wire must be
routed at least 1.5 m in front of and
behind the docking station in a
straight line and at right angles to
the floor plate. ( 11.14)
0478 131 9933 A - EN