Checking Installation - Viking MI 632 Manuel D'utilisation

Continue initial installation by
pressing the OK button.
MI 632 C, MI 632 PC:
"GPRS" energy mode is activated
following successful linking.
( 11.11)
Interrupted reception
The robotic mower receives no
wire signal:
The text "No wire signal"
appears on the display.
The robotic mower receives a
faulty wire signal:
The text "Check wire signal"
appears on the display.
The robotic mower receives a
reversed-polarity wire signal:
The text "Connections swapped
or iMow outside" appears on the
display.
Possible cause:
– Temporary malfunction
– Robotic mower is not docked
– Perimeter wire has been connected
incorrectly (reversed polarity)
– Docking station is switched off or not
connected to mains supply
– Faulty plug connections
– Coiled power cable in the vicinity of the
docking station
– Excessively long perimeter wire ends
– Perimeter wire break
– Extraneous signals such as a mobile
phone or the signal from another
docking station
0478 131 9933 A - EN
– Live underground cables, reinforced
concrete or disruptive metals in the
ground under the docking station
– Maximum length of the perimeter wire
exceeded ( 12.1)
Remedy:
– Repeat linking without other corrective
action
– Dock the robotic mower (
– Connect the perimeter wire ends
correctly ( 9.8)
– Check the docking station mains
connection, roll out the power cable in
the vicinity of the docking station, do not
set down coiled
– Check the perimeter wire plug
connections, cut off excessively long
perimeter wire ends ( 9.8)
– Check the LED indicator on the docking
station ( 13.1)
– Repair the wire break
– Switch off mobile phones or nearby
docking stations
– Change position of the docking station
or remove interference sources under
the docking station
– Use perimeter wire with larger cross
section (special accessory)
Following the appropriate corrective
action, repeat linkage by pressing
the OK button.
If the measures described above do
not result in a correct wire signal
then contact a VIKING specialist
dealer.

9.10 Checking installation

15.7)
Start the test run by pressing the OK
button – this does not activate the
mowing blade.
The robotic mower alternately
follows the edge of the mowing
area in both directions during
running operation after initial
installation. Edge following should
therefore also be checked in both
directions during initial installation.
MI 632 C, MI 632 PC:
The test run is used to define the
home area of the robotic mower.
( 14.5)
As the robotic mower follows the edge,
walk behind it and ensure:
113