Installation Material; Installing The Battery - Viking MI 632 Manuel D'utilisation

An installation video is available
at the www.viking-garden.com
homepage.
Your VIKING specialist dealer can
provide you with further information
on installing the robotic mower.
The installation assistant is re-
activated following a reset (reset to
factory defaults). ( 11.17)
Preparatory measures:
● Mow the lawn using a conventional
lawn mower prior to initial installation
(ideal grass height of 3 to 4 cm).
● In the case of a hard and dry surface,
water the mowing area lightly in order to
make it easier to drive in the fixing pins.
● MI 632 C, MI 632 PC:
The robotic mower must be activated by
a VIKING specialist dealer and
associated with the owner's e-mail
address. ( 10.)
When navigating through the
menus, follow the instructions in the
section entitled "Operating
instructions". ( 11.1)
You can select options, menu items
and buttons using the control pad.
You can open submenus and
confirm selections using the
OK button.
Use the Back button to
leave the active menu or
jump one step back in the
installation assistant.
If errors or faults occur during the
initial installation, a corresponding
message appears in the display.
( 24.)
0478 131 9933 A - EN

9.2 Installation material

If the perimeter wire is not routed by the
VIKING specialist dealer, additional
installation material not included in the
standard equipment will be required to be
able to operate the robotic mower. (
Different installation kits are available with
the following contents (tailored to the size
of the mowing area): Perimeter wire on
reel (1) as well as fixing pins (2), press-fit
connectors (3) and wire connectors (4).

9.3 Installing the battery

Lithium-ion batteries must be
treated with particular care. VIKING
recommends that you have the
battery installed by a VIKING
specialist dealer. A defective
battery must only be replaced by a
VIKING specialist dealer.
The battery remains permanently
installed in the robotic mower,
removal is only necessary prior to
disposal of the machine. (
● Set the lowest cutting height (level 1).
( 9.4)
● Place the robotic mower on its back on
a suitable surface.
18.)
Insert the battery (C) as shown and allow it
to engage.
20.1)
103