Standard Spare Parts; Accessories; Minimising Wear And Preventing Damage - Viking MI 632 Manuel D'utilisation

● Carefully clean all external parts of the
robotic mower and the docking station.
● Store the robotic mower together with
the docking station and the power
supply unit in the normal position and in
a dry and locked place that is generally
free of dust. Dock the robotic mower in
the docking station. Make sure that the
machine is kept out of the reach of
children.
● Always store the robotic mower in good
operational condition.
● Keep all screws tightly fastened,
replace danger signs and warnings on
the machine that have become illegible,
check the entire machine for wear and
damage. Replace all worn or damaged
parts.
● Any machine faults must be completely
remedied prior to storage.
Never place or store objects on the
robotic mower or on the docking
station.
Resuming operation of the robotic mower
following prolonged immobilisation:
The date and time may need to be
corrected following prolonged
immobilisation. Appropriate
selection windows are displayed
during initial operation. If the
selection windows are not
automatically displayed, check the
date and time in the "Settings"
menu and correct if necessary.
( 11.11)
● Prepare the mowing area:
Remove foreign objects and cut high
grass short using a conventional lawn
mower.
148
● Install the docking station (
connect the perimeter wire. (
● Charge the battery ( 15.8)
● Check the mowing plan and change as
necessary ( 11.6)
● Switch on automatic mowing (
● MI 632 C, MI 632 PC:
If necessary, activate the GPRS energy
mode ( 11.11) and switch on GPS
protection. ( 11.16)

17. Standard spare parts

Mowing blade:
6309 702 0102
Battery AAI 131:
for: MI 632, MI 632 C
6309 400 6511
Battery AAI 201:
for: MI 632 P, MI 632 PC
6309 400 6501

18. Accessories

Installation kits:
iKit S for mowing areas up to 500 m
6909 007 1011
iKit L for mowing areas from 2000 m
2
4000 m
6909 007 1012
Fixing pins AFN 075:
6301 007 1010
Perimeter wire ARB 501:
Length: 500 m
Diameter: 3,4 mm
0000 400 8625
Wire connector ADV 010:
6909 007 1090
9.6) and Press-fit connector AKS 010 (red):
9.8) for wire diameter: 2,3 mm
6909 007 1095
Press-fit connector AKS 011 (blue):
for wire diameter: 3,4 mm
6909 007 1096
11.5)
Additional accessories are available for
the machine.
Further information is available from your
VIKING specialist dealer, on the internet
(www.viking-garden.com) or in the
VIKING catalogue.
For safety reasons, only
accessories approved by VIKING
may be used with the machine.
19. Minimising wear and
preventing damage
Important information on maintenance
and care of the product group
Robotic mower, battery powered
VIKING assumes no liability for material or
personal damage caused by the non-
observance of information contained in the
operating instructions, in particular with
regard to safety, operation and
maintenance, or which arise through the
2
use of unauthorised attachment or spare
parts.
2
–
Please always observe the following
important information for the prevention of
damage or excessive wear to your VIKING
machine:
1. Wearing parts
Some parts of the VIKING machine are
subject to normal wear even when used
properly and must be replaced in due time
depending on type and duration of use.
These include:
0478 131 9933 A - EN