Viking MI 632 Manuel D'utilisation page 113

Insert the perimeter wire (1) into the cable
guides in the floor plate and guide it
through the socket (2).
Cut the ends of the perimeter wire (1) to a
free length of approx. 10 cm.
0478 131 9933 A - EN
Precisely observe the free length
and do not roll up protruding wire
ends. Excessively long free ends
can interfere with correct operation
of the robotic mower.
Fasten the press-fit connectors (1) onto
the cable ends using suitable pliers –
ensure correct engagement.
The press-fit connectors are
intended for one-time use and must
not be reused following removal.
Additional press-fit connectors are
available from a VIKING specialist
dealer. ( 18.)
Attach the connector (1) as
shown. Ensure correct
connection of the left and right
perimeter wire ends – do not interchange
the wire ends.
Close the cover of the cable duct (2).
Check the routing of the perimeter wire:
The two perimeter wire ends must be
routed as shown. If necessary they can
also be bound together using a
commercially available cable tie.
● After completing this installation
work, press the OK button on the
control panel.
Fit the cover as described in the "Installing
the docking station" section. ( 9.6)
111