Manual Mowing; Safety Devices; Stop Button; Disabling Device - Viking MI 632 Manuel D'utilisation

The robotic mower can be
operated reliably and
without interference in
close vicinity to other
robotic mowers. The wire
signal meets the EGMF
(European Garden
Machinery Federation) standard with
regard to electromagnetic emissions.

4.2 Manual mowing

With the robotic mower (1), it is also
possible to mow the lawn as with a
manually operated lawn mower. For this
purpose, remove the control panel (2),
select the "Hand control" option in the
"Commands" menu, activate the mowing
blade and self-propulsion and walk behind
the robotic mower. ( 15.6)
The impact sensor and edge
limitation are disabled during
manual mowing.
94

5. Safety devices

The machine is equipped with several
safety devices for safe operation and for
the prevention of improper use.
Risk of injury!
If a safety device is found to be
defective, the machine must not be
operated. Consult a specialist
dealer; VIKING recommends
VIKING specialist dealers.

5.1 STOP button

When the red STOP button on the top of
the robotic mower is pressed, operation of
the machine is stopped immediately. The
mowing blade comes to a standstill within
a few seconds and the message "STOP
button pressed" appears in the display.
The robotic mower cannot be operated
and is safe while the message is active.
( 24.)
When automatic mowing is
switched on, following
confirmation of the message with
OK, the system enquires
whether automatic operation is to be
continued.
If the response is Yes, the robotic mower
continues to mow the lawn in accordance
with the mowing plan.
If the response is No, the robotic mower
remains stationary in the mowing area and
automatic mowing is switched off. (
Pressing and holding the STOP
button also activates the disabling
device. ( 5.2)

5.2 Disabling device

The robotic mower must be
disabled prior to any
maintenance or cleaning work,
prior to transportation and prior
to inspection.
The robotic mower cannot be operated
when the disabling device is activated.
Activating the disabling device:
– Press and hold the STOP button
– in the Commands menu
– in the Safety menu.
Activating the disabling device via the
Commands menu:
● In the "Commands" menu, select the
"Lock iMow" entry and confirm with the
OK button. (
Activating the disabling device via the
Safety menu:
● Open the "Safety" submenu in the
"Settings" menu. (
● Select the "Lock iMow" entry and
confirm with the OK button.
Deactivating the disabling device:
● When required, wake up the machine
by pressing any button.
● Unlock the robotic mower using
the illustrated button
combination. For this purpose,
press the Mow button and the
OK button in the sequence illustrated.
11.5)
11.5)
11.16)
0478 131 9933 A - EN