14.6 Manual mowing
Do not activate the mowing blade or set
the lowest cutting height in high grass.
The robotic mower load must never cause
the mowing motor speed to drop
significantly. If the speed drops or the
robotic mower slows down, select a higher
cutting height setting.
15. Operating the machine
15.1 Preparation
An installation assistant is available
for initial installation. (
● Install the docking station (
● Route the perimeter wire (
connect (
9.8)
● Remove foreign bodies (e.g. toys,
tools) from the mowing area.
● Charge the battery (
15.8)
● Set the time and date (
● Check the mowing plan and adapt if
necessary – in particular it must be
ensured that third parties keep away
from the danger area during active
times. (
11.6)
Mow very high grass until it is short
using a conventional lawn mower
prior to use of the robotic mower
(e.g following a lengthy break).
0478 131 9933 A - EN
15.2 Removing and installing the
control panel
The control panel can be removed from
the robotic mower as required in order to
perform manual mowing or to e.g. change
the programming.
Automatic operation of the robotic mower
is only possible when the control panel is
inserted.
Removing the control panel:
● In running operation, press the
STOP button before removing the
control panel.
9.)
9.6)
9.7) and
11.11)
Lift the rear of the control panel (1) with a
slight tug and remove it from the robotic
mower. It remains connected to the
machine via a spiral cable.
Inserting the control panel:
Stow the spiral cable (1) in the housing
compartment. Tilt the control panel
backwards slightly, insert the retainers (2)
in the recesses in the housing (3), then
press down the control panel at the front
and allow to engage.
15.3 Adapting the programming
Current programmes can be seen in the
mowing plan or, in the case of the models
MI 632 C, MI 632 PC, in the VIKING iMow
app. (
11.6)
The mowing plan is calculated based on
139