Secondary Areas - Viking MI 632 Manuel D'utilisation

– around obstacles that are not
sufficiently sturdy
– around obstacles that are too low.
Minimum height: 10 cm
VIKING recommends
● blocking off obstacles by means of no-
go areas or removing them,
● checking no-go areas after initial
installation or after changes to the wire
installation using the "Test edge"
command. ( 11.14)
Minimum clearance A from the no-go
area to the edge loop: 54 cm
This clearance corresponds to 2 iRuler
lengths.
132
In order for docking to take place
smoothly, no no-go area must be installed
within a radius of at least 2 m around the
docking station (1).
Route the perimeter wire (1) from the edge
to the obstacle with the correct clearance
(use iRuler) around the obstacle (2) and
attach it to the ground with a sufficient
number of fixing pins (3). Then route the
perimeter wire back to the edge again.
The perimeter wire must be routed
parallel and without crossover in the
linking sections. ( 12.10)
The perimeter wire must be routed around
very small obstacles (e.g. around an
individual tree) with the illustrated
clearance (clearances A and C on the
iRuler) so that the robotic mower does not
hit the obstacle when going around it.
Clearance: 37 cm

12.8 Secondary areas

Secondary areas are parts of the mowing
area that cannot be mown fully
automatically by the robotic mower
because access is not possible. In this
manner, several separate mowing areas
can be surrounded with a single perimeter
wire. The robotic mower must be manually
taken from one mowing area to another.
The mowing operation can be initiated via
the commands "Start mowing" (
"Start time-delayed mowing" (
0478 131 9933 A - EN
11.5) or
11.5).