Power Supply Unit Plug; Storage And Winter Break - Viking MI 632 Manuel D'utilisation

● Bridge the break with the aid of a wire
connector ( 12.15). If necessary, re-
route the perimeter wire in the area of
the break.
● Press the ON/OFF button on the
docking station. Once the wire
break has been correctly
rectified, the red LED illuminates.
( 13.1)
Fine search with control panel inserted:
Lift the robotic mower slightly by the
carrying handle (1) and relieve the weight
on the drive wheels. Push the machine,
resting on its front wheels and follow the
perimeter wire (2).
The further procedure corresponds to the
search with the control panel removed.

16.8 Power supply unit plug

The power supply unit is equipped with a
removable plug.
This plug can be removed if the power
supply unit is installed inside a building
and therefore the power cable must be
routed through a hole in the wall.
0478 131 9933 A - EN
Risk of injury!
Disconnect the mains plug and
unplug the power supply unit from
the docking station before
performing any work on the power
supply unit.
Read the instructions in the section
"Warning – dangers caused by
electrical current". (
Install the blue cable (BL) and the brown
cable (BR) in the plug as illustrated.
Tighten screws (1).

16.9 Storage and winter break

Note the following points when storing the
robotic mower for long periods (e.g. winter
break):
● Charge the battery ( 15.8)
● Switch off automatic mowing (
● Activate the highest safety level
( 11.16)
● MI 632 C, MI 632 PC:
Activate ECO energy mode (
● Activate the disabling device (
● Disconnect the power supply unit plug
from the mains
● Remove the docking station cover
( 9.6)
6.3)
Disconnect the perimeter wire (1). Open
the cover of the cable duct (2) and guide
the perimeter wire together with the press-
fit connectors out of the docking station
socket.
Do not remove the press-fit
connectors from the perimeter wire;
they are intended for one-time use.
Additional press-fit connectors are
available from a VIKING specialist
dealer. (
Do not remove the perimeter wire
from the mowing area.
● Disconnect the power cable from the
docking station.
11.5)
● Install the docking station cover.
( 9.6)
● Remove the docking station.
● Protect the terminals (connectors) of
11.11)
the perimeter wire from environmental
5.2)
influences (e.g. wrap with suitable
insulating tape).
17.)
147