Docking Station; Docking Station Controls - Viking MI 632 Manuel D'utilisation

Insert loose, unstripped wire ends (1) to
the stop in the wire connector (2). Press
the wire connector together using suitable
pliers – ensure correct engagement.
Attach the perimeter wire strain relief to the
ground with two fixing pins as shown.
0478 131 9933 A - EN

13. Docking station

13.1 Docking station controls

A red LED (1) and a green LED (2) provide
information on the status of the docking
station and the wire signal.
With the Home button (3), the robotic
mower can be brought back to the docking
station during a mowing operation.
The docking station and consequently the
wire signal can be switched on and off
using the ON/OFF button (4).
Red LED illuminates
Red LED flashes
Green LED illuminates
Green LED flashes
LED is switched off
Activity Red
Standby
Wire signal OK
Charging
Homecall
Wire break
Wire break search
Fault
Home button:
During a mowing operation,
pressing the Home button activates
Homecall.
The robotic mower ends the running
mowing operation, searches for the
perimeter wire and returns to the docking
station to recharge the battery. No further
mowing operation takes place in the
current active time.
Homecall remains active until the
robotic mower is docked or until the
Home button is pressed again.
ON/OFF button:
Pressing the ON/OFF button is not
necessary for automatic mowing of
the mowing area. The wire signal is
switched on and off automatically.
If the robotic mower is not docked,
pressing the ON/OFF button activates the
docking station. The wire signal remains
active for 48 hours if the robotic mower
has not previously docked.
During running operation, the wire signal is
switched off by pressing and holding the
button for 3 seconds and the robotic
Green
137