Perimeter Wire - Viking MI 632 Manuel D'utilisation

6. Alarm signal:
For switching on and off the acoustic
signal that sounds when the robotic
mower hits an obstacle.
7. Menu signal:
For switching on and off the acoustic
click that sounds when a menu is
opened and a selection is confirmed with
OK.
8. Child lock:
For switching on and off the device that
prevents the mowing blade from running
when the machine is being played with.
Function:
If the impact sensor is triggered several
times in succession within a short time (for
example when a child is playing with the
robotic mower), the mowing blade is
switched off and the robotic mower stops
with an appropriate message.
If the impact sensor is not triggered again,
the robotic mower continues automatic
mowing after a few seconds.
9. Keylock:
When the keylock is switched on,
the buttons on the control panel
can only be operated if the Back
button is pressed and held and the
control pad is then pressed forwards.
The keylock is activated 2 minutes after
the last button has been pressed.
10. Link iMow and dock:
Following initial operation, the
robotic mower can only be operated
in conjunction with the docking station
supplied.
Following a replacement of the docking
station or of electronic components in the
robotic mower or for operation of the
robotic mower on an additional mowing
128
area using a different docking station, the
robotic mower and docking station must be
linked.
● Install the docking station and connect
the perimeter wire. ( 9.6), (
Lift the robotic mower slightly by the
carrying handle (1) and relieve the weight
on the drive wheels. Push the machine,
resting on its front wheels, into the docking
station.
● After pressing the OK button,
enter the PIN code. The robotic
mower will then search for the
wire signal and save it automatically.
This process takes several minutes.
( 9.9)
No PIN code is required in the
safety level "None".
11.17 Service
1. Blade change:
Installation of a new mowing blade is
confirmed with OK.
If the blade has been in use for
more than 200 hours, the message
"Replace mowing blade" appears.
( 16.4)
9.8)
2. Find wire break:
If the red LED on the docking station
flashes, there is a break in the perimeter
wire. ( 13.1)
The assistant to find the break is activated
with OK.
● Finding wire break (
3. Reset settings:
The robotic mower is reset to the factory
defaults with OK, the installation assistant
is restarted. (
● Enter the PIN code after pressing
the OK button.
No PIN code is required in the
safety level "None".

12. Perimeter wire

Before routing the
perimeter wire,
particularly prior to initial
installation, read the
entire section and plan the wire
routing in detail.
Perform initial installation using the
installation assistant. (
Should you require support, your
VIKING specialist dealer will be
pleased to assist you with
preparation of the mowing area and
installation of the perimeter wire.
16.7)
9.5)
9.)
0478 131 9933 A - EN