Stopping The Engine; Cleaning The Machine; Checking Blade Wear - Viking MB 4 R Manuel D'utilisation

Masquer les pouces Voir aussi pour MB 4 R:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 49

11.2 Stopping the engine

● Release the motorstop lever (1).
The engine and blade come to a
standstill within 3 seconds.
11.3 Self-propulsion (MB 4 RT,
MB 4 RTP)
The MB 4 RT and MB 4 RTP
models feature front-wheel drive.
Switching on self-propulsion
● Start the engine. (
11.1)
● Pull the self-propulsion lever (1) to the
handlebar and hold.
Self-propulsion is switched on and the
lawn mower moves forwards.
Switching off self-propulsion
● Release the self-propulsion lever (1).
Self-propulsion is switched off and the
lawn mower comes to a standstill.
The engine and blade continue to run.
40
12. Maintenance
16
Risk of injury!
Carefully read the section "For your
safety" (
4.), particularly the
subsection "Maintenance and
repairs" (
safety instructions exactly before
17
performing any maintenance or
18
cleaning operations on the
machine.
Allow the machine too
cool and detach the
spark plug socket before
performing any
maintenance or cleaning
operations.
Annual service by the specialist dealer:
The lawn mower should be inspected once
annually by a specialist dealer. VIKING
recommends VIKING specialist dealers.

12.1 Cleaning the machine

Maintenance interval:
After each use.
Risk of injury!
Stop the engine, allow the machine
to cool and detach the spark plug
socket.
4.7), and follow all
19
Placing machine in service position
● Set the cutting height
adjustment lever to the
highest position (1).
(
8.5)
● Loosen handlebar screw
fastening/quick clamping device (2)
and fold down upper handlebar (3) to
the rear.
● Lift up the machine at the front and
place in the service position as shown.

12.2 Checking blade wear

Maintenance interval:
Before each use.
Risk of injury!
Blades are subjected to differing
degrees of wear depending on the
location and duration of use. If you
use the machine on sandy ground
or use it frequently under dry
conditions, the blade will be
subjected to greater loads and will
wear more quickly than the
average.
A worn blade may break off and
cause serious injuries. The
instructions for blade maintenance
must therefore always be
observed.
Check procedure
Risk of injury!
Observe the safety instructions in
the "For your safety" section.
(
4.7)
● Place the machine in the service
position. (
12.1)
● Clean the mowing blade (1).
0478 111 9924 C - EN
20

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Mb 4 rtMb 4 rtpMb 2 rMb 2 rcMb 2 rt

Table des Matières