Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
D-24
Parameter Reference
Device Commands
Update Firmware
Parameters::Device Manager::Device Commands
PNO
Parameter Descriptions
1002
Update Firmware
This parameter is only visible when an SD card with a firmware update file is inserted into the drive. Changing this parameter to
TRUE will start the firmware update procedure.
Following a firmware update it is advisable to power re-run the Setup Wizard, D-94.
1001
Save All Parameters
When a parameter is modified via the GKP or via the built-in web page the parameter value is saved automatically. When a
parameter is modified via another source, (for example via the Modbus TCP/IP communications protocol), the value will not be saved
automatically. In this case a save may be instigated by changing this parameter from FALSE to TRUE.
AC30V series Variable Speed Drive
Publicité
Table des Matières
Dépannage
