Parker AC30V Série Manuel Technique page 241

PNO Parameter Descriptions
1538
Full Restore
If the parameter 1537 Clone Direction is set to LOAD FROM FILE, then the parameter Full Restore determines if a full restore or a
partial restore is required from the file specified.
If YES is chosen then all the saved parameters and the saved application will be loaded including 'drive unique' parameters.
If PARTIAL is chosen then the user has the choice of what to restore, however 'drive unique' parameters will keep their current
values. The following clone parameters apply:
1539 Application
1541 Power Parameters
1540 Other parameters
Notes:
- If the power stack of the drive is different to the power stack from which the clone file was saved and the user chooses YES then
the clone load will not be permitted. However the clone load will be permitted if the control module on which the user is restoring
is not attached to a power stack, or if PARTIAL is chosen instead.
- The power parameters cannot be restored from a clone file that was saved on a control module with the parameter 0989 Power
Stack Required set to NONE.
Enumerated Value : Full Restore
1539
Application
If the parameter 1538 Full Restore is set to PARTIAL, then the parameter Application allows the user to either load the application
from the file or to leave the currently installed application.
Enumerated Value : Application
AC30V series Variable Speed Drive
0 : YES
1 : PARTIAL
0 : LOAD FROM FILE
1 : LEAVE CURRENT APP
D-15
Parameter Reference