Using The Full Length X-Ray Cassette System - Stryker 1037 Manuel D'utilisation

English

USING THE FULL LENGTH X-RAY CASSETTE SYSTEM

Center the patient on the stretcher by using the position indicator labels that are located on both ends of the stretcher
(Figure 15.1).
The cassette drawer is located on the side of the stretcher and can be identified by the yellow handle (B).
To load the cassette into the drawer:
1. Pull the handle (B) to pull the drawer fully out.
2. Loosen the knob (C) and adjust the sliding track to secure the cassette. Tighten the knob (C) to center the
cassette in the drawer.
3. Push the drawer fully back under the stretcher litter.
To position the drawer to the desired location:
1. Squeeze the red handles (A) and pull toward either end of the stretcher, depending on the location needed.
Note: The drawer can be moved the entire length of the stretcher.
2. Release the red handles (A) to lock the drawer in place.
After the X−ray procedure is completed, reverse the above steps to remove the cassette.
Return To Table of Contents
1-28
Operation Guide
Figure 15.1: Position Indicator
Figure 15.2: X-Ray Cassette System
1037-009-005 REV B
C
B
A
www.stryker.com