Adjusting Trendelenburg/Reverse Trendelenburg Positions - Side Control - Stryker 1037 Manuel D'utilisation

ADJUSTING TRENDELENBURG/REVERSE TRENDELENBURG POSITIONS - SIDE CONTROL

Litter height must first be raised in order to achieve a Trendelenburg or reverse Trendelenburg position.
CAUTION
• To avoid damage, remove any equipment that may be in the way before raising or lowering the litter height.
• Do not raise the unit (hydraulics on base) with a patient lift under the stretcher.
For Trendelenburg positioning (head down), depress the side of pedal (B) closest to the head end (see Figure 2 on
page 1-12).
For reverse Trendelenburg positioning (foot down), depress the side of pedal (B) closest to the foot end (see
Figure 2 on page 1-12).
Note: The higher the litter is before pedal (B) is activated, the greater the Trendelenburg or reverse Trendelenburg
angle will be. (Maximum Trendelenburg angle is +18°. Maximum reverse Trendelenburg angle is -18°.)
www.stryker.com
Operation Guide
1037-009-005 REV B
Return To Table of Contents
1-13
English