Publicité
18.5.4
Cutting threads
The machine can be used to cut metric or inch threads. With the feed direction selector lever (A)
on the headstock, you can set the direction of rotation for threading (left/right thread). You can set
the pitch with the feedrate selectors. The shift lever tapping (lock nut) (Q) must always be closed
during the thread cutting process.
18.5.5
Thread pitch table / longitudinal feed for metric threads
The metric threads range from 0.8 to 14.0 mm, 36 steps are available.
18.5.6
Thread pitch table / longitudinal feed for imperial threads
Imperial threads range from 2 to 28 TPI, 30 steps are available.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
Cross or longitudinal feed:
engaging lever (R)
OPERATION
74
ED1000KDIG | ED1500KDIG
Publicité
