Publicité
Residual risks can be minimized if the "Safety instructions" and the "Intended use" as well as the
operating instructions are observed. Due to the design and construction of the machine,
hazardous situations may occur which are identified as follows in these operating instructions:
A safety instruction designed in this way indicates an imminently hazardous situation
which, if not avoided, will result in death or serious injury.
Such a safety instruction indicates a potentially hazardous situation which, if not
avoided, may result in serious injury or even death.
A safety instruction designed in this way indicates a potentially hazardous situation
which, if not avoided, may result in minor or moderate injury.
A safety notice designed in this way indicates a potentially hazardous situation which,
if not avoided, may result in property damage.
Irrespective of all safety regulations, your common sense and appropriate technical
suitability/training are and will remain the most important safety factor for error-free operation of
the machine. Safe working primarily depends on you!
16
TRANSPORT
Damaged or insufficiently strong hoists and load slings can result in serious injury or
even death. Before use, therefore, check hoists and load slings for adequate load-
bearing capacity and perfect condition. Secure the loads carefully. Never stand under
suspended loads!
To ensure proper transport, observe the instructions and information on the transport packaging
regarding centre of gravity, attachment points, weight, means of transport to be used and the
prescribed transport position, etc.
Transport the machine in its packaging to the place of installation. To manoeuvre the machine in
the packaging, a pallet truck or forklift truck with the appropriate lifting force can be used, for
example. Ensure that the selected lifting equipment (crane, forklift, pallet truck, load sling, etc.) is
in perfect condition. Lifting and transporting the machine may only be carried out by qualified
personnel with appropriate training for the lifting equipment used.
Avoid using sling chains as there is a risk of damaging the feed screw or the lead
screw. Make sure that the lead screw, feed screw and selector shaft of the lathe are not
touched by the lifting slings when lifting. Never lift the machine by the spindle!
To position the machine at the installation location, proceed as follows:
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
DANGER
WARNING
CAUTION
NOTICE
WARNING
NOTICE
TRANSPORT
59
ED1000KDIG | ED1500KDIG
Publicité
