Publicité
take into account that the operation, maintenance and repair of the machine must be possible
without restrictions at all times.
The selected installation location must ensure a suitable connection to the electrical mains.
17.1.4
Anchorless assembly
The use of machine feet (not supplied) facilitates levelling of the machine and reduces
vibrations.
After the machine has been brought into the desired position at the intended installation location,
it must be levelled in the longitudinal and transverse axes using the pressure screws.
17.1.5
Anchored assembly
Insufficient rigidity of the substrate leads to the superposition of vibrations between
the machine and the substrate (natural frequency of components). If the stiffness of
the overall system is insufficient, critical speeds are reached quickly, which leads to
poor turning results.
Use the anchored assembly to achieve a rigid connection with the ground. This reduces the
vibration potential. The anchored assembly is always useful when turning knives or turning tools
with HM alloy are to be used and/or large parts up to the maximum capacity of the machine are to
be machined.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
NOTICE
A ... Head Stock;
B... Precision Balance;
C ... tailstock;
D ... saddle & cross slide
E ... bed slideway
1.
Place the adjusting disks (3) under the machine base.
2.
Mount the adjusting screws (1).
3.
Align the lathe with a precision balance (accuracy: 0.02
mm over 1000 mm length).
4.
After levelling, secure the set screws with lock nuts (2) to
prevent them from turning.
5.
Check the alignment after a few days of use of the
machine and, if necessary, adjust it according to the
following instructions
NOTICE
1.
Place the machine on the anchor bolts
(MF) adjusting disks (3).
2. Then align the machine and tighten the
screws (1).
3. Check the alignment of the machine
again after having tightened the counter
nuts (2).
4. Repeat levelling procedure if necessary.
ASSEMBLY
61
ED1000KDIG | ED1500KDIG
Publicité
