Publicité
18.10.5
Plain turning and recessing
18.10.6
Fixing the lathe slide
18.10.7
Turning between tips
18.10.8
Turning short taper with the top slide
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
When facing, the turning tool is moved at right angles to
the axis of rotation. The feed is done manually with the
handwheel of the facing slide. The feed of the cutting depth
is effected by the top slide or the bed slide.
The cutting force occurring during facing, grooving or
cutting-off operations can cause the lathe slide to move.
Therefore fasten lathe slide with the fixing screw.
Workpieces that require a high concentricity are
machined between the tips. A centre hole is
drilled in both face turned faces of the
workpiece. The turning heart is clamped onto
the workpiece. The driving pin, which is screwed
into the chuck flange, transmits the torque to
the rotary heart. The fixed centering point is
located in the centre hole of the workpiece on
the spindle head side. The rotating center point
is located in the centering hole of the workpiece
on the tailstock side.
The short taper is turned by hand with the top slide. The
upper slide is swivelled according to the desired angle. The
infeed takes place with the cross slide:
1. Loosen the two clamping screws at the front and rear of the
upper slide.
2. Turn the upper slide to the desired position.
3. Clamp the upper slide again.
OPERATION
80
ED1000KDIG | ED1500KDIG
Publicité
