Publicité
Note: Before lifting, check that the tailstock is clamped. Ensure that the load stop is balanced. If
necessary, change the position of the bed carriage and/or tailstock to obtain a balanced load stop.
17
ASSEMBLY
17.1
Preparatory activities
17.1.1
Checking delivery content
Always note visible transport damage on the delivery note and check the machine immediately
after unpacking for transport damage or missing or damaged parts. Report any damage to the
machine or missing parts immediately to your retailer or freight forwarder.
17.1.2
Cleaning and lubrication
Before you install and commission the machine at the intended location, carefully remove the
anti-corrosion protection and grease residues.
Under no circumstances should you use nitro thinner or other cleaning agents that could attack
the machine's paint.
Oil bare machine parts (e.g. machine bed, tailstock sleeve, feed spindle) with an acid-free
lubricating oil.
17.1.3
Site requirements
Place the machine on a solid surface. A concrete floor is the best foundation for the machine. If
necessary, use an underframe.
The space required by the machine and the required load-bearing capacity of the subfloor result
from the technical data (dimensions, weight) of your machine. When designing the working area
around the machine, observe the local safety regulations. When dimensioning the required space,
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
1.
Prepare two sufficiently strong round
steel bars (length approx. 800 mm, Ø
approx. 35 mm).
2. Guide the round steel bars through the
prepared holes (1) in the stand.
3. Attach a lifting sling to each of the four
ends of the two round steel bars.
4. Lift the machine with a suitable conveyor
(e.g. crane).
ASSEMBLY
60
ED1000KDIG | ED1500KDIG
Publicité
