Publicité
DESCRIPTION DES CODES D'ANOMALIE (DTC) DE LA TRANSMISSION ALLISON 5
GÉNÉRATION
DTC
C1312 Retarder Request Sensor Failed Low
C1313 Retarder Request Sensor Failed High
P0122
Pedal Position Sensor Circuit Low Voltage
P0123
Pedal Position Sensor Circuit High Voltage
P0218
Transmission Fluid Over Temperature
P0562
System Voltage Low
P0602
TCM Not Programmed
P0604
Control module random access memory (RAM)
P0614
Torque Control Data Mismatch - ECM/TCM
P0634
TCM Internal Temperature Too High
P0642
Sensor Reference Voltage "A" Circuit Low
P0643
Sensor Reference Voltage "A" Circuit High
P0657 Actuator Supply Circuit Voltage 1 Open (HSD 1)
P0658
Actuator Supply Voltage 1 (HSD1) Low
P0659
Actuator Supply Voltage 1 (HSD1) High
P0703
Brake Switch Circuit Malfunction
P0708
Transmission Range Sensor Circuit High Input
P070C Transmission Fluid Level Sensor Circuit – Low Input
P070D Transmission Fluid Level Sensor Circuit – High Input
P0712
Transmission Fluid Temperature Sensor Circuit Low Input
Transmission Fluid Temperature Sensor Circuit High
P0713
Input
P0715
Turbine Shaft Speed Sensor Circuit
P0716
Turbine Shaft Speed Sensor Circuit Performance
P0717
Turbine Shaft Speed Sensor Circuit No Signal
P071A RELS Input Failed On
P071D General Purpose Input Fault
P0720
Output Shaft Speed Sensor Circuit
P0721
Output Shaft Speed Sensor Circuit Performance
P0722
Output Speed Sensor Circuit No Signal
P0725
Engine Speed Sensor Circuit
P0726
Engine Speed Sensor Circuit Performance
P0727
Engine Speed Sensor Circuit No Signal
th
P0729
Incorrect 6
Gear Ratio
st
P0731
Incorrect 1
Gear ratio
nd
P0732
Incorrect 2
Gear ratio
Annexe C – Autres fonctions de la transmission Allison
Description
CHECK
Inhibited Operation
Light
Description
May inhibit retarder operation if not
No
using J1939 datalink
May inhibit retarder operation if not
No
using J1939 datalink
Use default throttle values. Freezes
No
shift adapts.
Use default throttle values. Freezes
No
shift adapts.
Yes
Use default sump temp
No
Inhibit TCC Operation, DNA
Yes
Lock in Neutral
Yes
Lock in Neutral
Allows operation only in reverse
Yes
and second range.
Yes
SOL OFF (hydraulic default)
Yes
Default sensor data used
Yes
Default sensor data used
SOL OFF, DNA, Inhibit TCC
Yes
operation, Inhibit main modulation
Yes
DNS, SOL OFF (hydraulic default)
Yes
DNS, SOL OFF (hydraulic default)
No Neutral to Drive shifts for refuse
packer. TCM inhibits retarder
No
operation if a TPS code is also
active.
Yes
Ignore defective strip selector inputs
No
None
No
None
Yes
Use default sump temp
Yes
Use default sump temp
Yes
DNS, Lock in current range
Yes
DNS, Lock in current range
Yes
DNS, Lock in current range
Yes
Inhibit RELS operation
Yes
None
Yes
DNS, Lock in current range
Yes
DNS, Lock in current range
Yes
DNS, Lock in current range
No
Default to turbine speed
No
Default to turbine speed
No
Default to turbine speed
Yes
DNS, Attempt 5
Yes
DNS, Attempt 2
Yes
DNS, Attempt 3
9
IÈME
th
rd
, then 3
nd
th
, then 5
rd
th
, then 5
Publicité
