Copying Flight Phases Menu; Copy; Setting The Transition Speed For Switching Flight Phases Menu; Speed - Multiplex COCKPIX SX Manuel D'utilisation

C SX
OCKPIT
15.9.3. On-screen display of the active flight
phase
The top section of the screen displays the flight phases
in the form of three figures.
When you are flying (INFO display visible) this applies:
PH Display
switch
position
1
1
2
2
3
3
When you make changes in the menus of the C
SX, the three figures indicate whether the selected
value is specific to one flight phase, and, if so, to which
flight phase the currently displayed value applies.
PH Display
switch
123
1
123
2
123
3
Important: non flight phase-specific values
If only one constantly visible figure is displayed, the
selected value applies equally to all flight phases.
15.9.4. Copying flight phases
PHASENS
Menu: (
What is copied?
• The current trim settings for AILERON, ELEVATOR
and RUDDER
• Mixer input Q ->Q aileron input to ailerons
(differential)
• Mixer inputs for the free mixers
• Transmitter control settings
Dual Rate for AILERON, ELEVATOR,
RUDDER
Fixed values for AILERON, ELEVATOR, RUDDER,
which are called up with the FIX button
The source is always the current flight phase, which
you have selected with the PH switch.
The destination for the copy is selected in the menu.
Active phase:
Flight phase 1
Flight phase 2
Flight phase 3
OCKPIT
The code number of
the active phase is
constantly displayed;
the other two flash.

) COPY

14.9.1.
15.10.2.
Moving to the COPY menu:
to MENU,
(MODEL appears),
to PHASES,
to COPY,
The number 0 flashes in the bottom line. Select phase
1 to 3 as destination using the 3-D digi-adjustor.
A further brief press
the copy process, and the flashing ceases.
Note: interrupting without making a copy
If you leave 0 as the destination, no copy will be made.
15.9.5. Setting the transition speed for switching
flight phases
Menu: (
The SPEED parameter can be adjusted to determine
the speed of transition from one flight phase to another.
Four settings are possible:
SPEED Transition
0
1
2
3
Moving to the SPEED menu:
to MENU, (SETUP appears),
(MODEL appears), (MODE appears),
to PHASES, ,
to SPEED,
17.
The current setting flashes. Select the desired value
using the 3-D digi-adjustor.
A brief press
process. The value is stored.
Page 56
(SETUP appears),
(MODE appears),
,
on the 3-D digi-adjustor triggers

) SPEED

PHASES
immediate
fast approx. 1 sec
moderate approx. 2 sec
slow approx. 3 sec
on the 3-D digi-adjustor concludes the