Copy; Setting The Transition Speed For Switching Flight Phases Menu; Speed; Virtual Swashplate Rotation Menu: (Mixer Rotor) V-Rot - Multiplex COCKPIX SX Manuel D'utilisation

C SX
OCKPIT
A-ROT PH
switch switch
1
OFF
2
forward
3
ON
back
any
auto-
rotation
Table 2: Flight phase indication in the menus
16.10.4. Copying flight phases
Menu: ( PHASES
The destination for the copy is selected in the menu.
The source is always the current flight phase, which
you have selected using the A-ROT and PH switches.
Moving to the Menu:
to MENU,
(MODEL appears),
to PHASES,
to COPY,
The number 0 flashes in the bottom line. Select phase
1 to 4 as destination using the 3-D digi-adjustor.
Check once more that you have selected the correct
source using the PH and A-ROT switches (
section 16.10.3.).
A further brief press on the 3-D digi-adjustor triggers
the copy process, and the flashing ceases.
Note: interrupting without making a copy
If you leave 0 as the destination, no copy will be made.
16.10.5. Setting the transition speed for switching
flight phases
PHASES
Menu: (
The SPEED parameter can be adjusted to determine
the speed of transition from one flight phase to another.
Four settings are possible:
SPEED Transition
0
immediate
1
fast
2
moderate
3
slow
Display
123
The code number of
the active phase is
123
displayed con-
stantly; the other
123
two flash.
All three code num-
123
bers flash.

) COPY

(SETUP appears),
(MODE appears),
(current value appears),
table 1 in

) SPEED

approx. 1 sec
approx. 2 sec
approx. 3 sec
Exception: Auto-rotation
If you switch to auto-rotation from flight phase 1, 2 or 3
the transition is always immediate, regardless of the
transition SPEED you have set.
Moving to the SPEED menu:
to MENU, (SETUP appears),
(MODEL appears), (MODE appears),
to PHASEN, ,
to SPEED,
The current setting flashes. Select the desired value
using the 3-D digi-adjustor (see table above).
A brief press
process. The value is stored.
16.11. Virtual swashplate rotation
Menu:
Virtual swashplate rotation electronically "rotates" the
swashplate. The purpose of this function is to prevent
the helicopter veering to one side when you apply a
PITCH-AXIS command.
Moving to the V-ROT menu:
to MENU, (SETUP appears),
to MIXER, (TAIL appears),
to ROTOR, (V-ROT appears),
The current value flashes in the bottom line. Use the 3-
D digi-adjustor to set a value within the range -100° to
100° (the "°" character is not displayed).
Negative values rotate the swashplate anti-clockwise,
positive values rotate it clockwise.
A brief press
process. The flashing ceases, and the value is stored.
V-ROT for other tasks
Even if the swashplate linkage is not in accordance
with the requirements stated in section 16.3.4., you can
still make adjustments using V-ROT.
Page 72
on the 3-D digi-adjustor concludes the
V-ROT
(MIXER ROTOR)
on the 3-D digi-adjustor concludes the