Menu Setup - Multiplex PROFI TX 16 MasterEdition Mode D'emploi

3. Menu setup

Flight Phases\Groups
There are now 3 groups each with 4 ight phases. When
switching groups, mixer parameters and other values are also
switched. Groups can be copied.
The following can be adjusted in the "Setup\Flight phases\
Groups" menu:
· The group switch: All switches are allowed, including a
MagicSwitch.
· The switch assignment: This determines on which switch
positions the individual groups lie. In the "OFF" position,
group switching is locked and group 1 is active.
· Copying the active group to another. If the active group is
selected as the target, the data set of the active group is
saved on the SD card (memory card).
Training
The teacher mode was extended with a number of function-
alities. It now offers individual switches and several mixer
options. The neutral position can be automatically compared.
Procedure:
a. Switch on training in the "Setup\Training" menu.
b. Select "Teacher" or "Pupil" mode.
c. Connect as "Teacher" to the pupil transmitter using the
installed Copilot component.
The copilot module provides the rst 7 servo channels of the
pupil transmitter (as before).
· Each pupil channel has a line in the assignment area, K1 to K7.
Here you can select which of the teacher's control functions
is to be controlled by the pupil channel.
· Two arrows indicate the directional movement of the trans-
mitter control from pupil and teacher. Using the REV/CLR
button, the pupil signal can be reversed if the corresponding
assignment eld is open.
· In the eld alongside it on the right, a switch can be assigned
to each of the teacher's control functions. Without a switch,
the pupil channel is always connected. All switches may be
used.
In all menus whose data sets are switched when the group
is switched, the group number is displayed at the end of the
header. The ight phase display of the status line displays the
group number as an index of the ight phase number. When
the group switching is activated for the rst time, the groups
are automatically created and lled with existing data from the
model memory.
Important:
The following is switched when the groups are switched: Flight
phase name, trim, trim increments, expo, D/R, travels, run-
ning speed (slow), curves, gyro (incl. contrl. axis), sequencer,
multi-position switch, all mixers.
The following remains the same:
Assignments, names, sensorics, timer, de nitions of the mixers
on the servo side, MagicSwitch setup.
Further options for training can be found underneath the pupil
channel list K1-K7:
· If desired, the "Mixer mode" may be activated. The signals
from teacher and pupil are mixed 1:1 and limited to 100%.
· Special case throttle: The zero point can be determined us-
ing "Throttle opt.". With the setting ON, it is in idle. The
signals are added together with the setting ON only in the full
throttle direction, meaning the teacher and pupil must both
remove the throttle for idle!
· Special case spoiler: The zero point can be de ned using
"Spoiler opt.". With the setting ON, it is on the spoiler's
zero point (retracted). The signals are added together with
the setting ON only in the direction of "Spoilers extended"!
· Deviations of the neutral positions between teacher and pupil
transmitter can be balanced using "zero points". Devia-
tions larger than +20/-10% are not corrected, because the
affected controllers are then probably not in the center. The
UNI/MPX switching is omitted. It is no longer required due to
the alignment. Pupil mode not always works in UNI format
(UNI format: Servo pulse length at +/- 100% servo travel,
1.5 ± 0.55ms).
13