Indirect Heat Electric Boiling Pan - Modular 90/80 PGD100 Traduction Des Instructions D'origine

When the heating switches off, the yellow
indicator light switches off too.
AT THE END OF SERVICE
Switch the heating off.
Switch the burners off.
Empty the well completely.
Turn the knob to position " 0 " .
14.

INDIRECT HEAT ELECTRIC BOILING PAN

The appliance is designed for cooking and
preparing food in water.
Do not light the pilot burner or leave it on when
there is no water in the well.
Do not activate the heating system when there is
no water in the well.
While the pasta cooker is on, the water level must
be maintained level with or above the minimum
level indicated on the rear wall of the well.
Use very fine grained salt, adding it to the well
when the water is boiling. Do not use
coarsegrained rock salt in the well.
At the end of each day, clean the well thoroughly in
order to prevent the formation of corrosive
deposits.
Restore the water level in the jacket every 2/3
working days.
See " FILLING THE JACKET ".
The appliance is equipped with an automatic reset
pressure switch which interrupts heating when
steam pressure in the jacket exceeds optimum
levels.
Heating restarts when steam pressure returns to
an acceptable level.
The intervention of the pressure switch ensures
reduced consumption of water in the jacket and
reduced appliance energy consumption overall.
The appliance is fi tted with a thermostat which
stops activation of heating in the event the water
in the jacket falls below the safety level. The red
indicator light on the control panel switches on.
Heating will restart after the water level in the
jacket has been restored.
See " FILLING THE JACKET ".
FILLING THE JACKET
FILL THE CAVITY WITH COLD MACHINE,
USING ONLY DEMINERALIZED WATER.
- Unscrew the anti-depression valve " S " from its
seat to access the jacket fi lling hole.
- Open the level tap " L ".
- Pour demineralized water into the filling hole.
- Stop pouring when water begins to flow from the
level tap "L ".
- Close the level tap " L ".
- Carefully screw back on the anti-depression valve "
S ".
FILLING AND EMPTYING OF THE TANK
FILLING
The control knob has the following positions:
OFF
(BLUE) COLD WATER FI LLING
ELECTRICAL POWER ON
(RED) HOT WATER FI LLING
Open the lid.
Turn the handle of the front discharge tap
clockwise. The tap is only completely closed when
the handle is in the vertical position.
Turn the control knob to select hot or cold water
for filling.
Water fills from dispenser place on the countertop.
Fill the well until the water is level with the
maximum level indicated on the wall of the well.
Do not use the appliance with the water level
above the maximum indicated level.
To interrupt filling, turn the knob to "0" or "1".
EMPTYING
34