Indirect Heat Gas Boiling Pan - Modular 90/80 PGD100 Traduction Des Instructions D'origine

Press the knob fully down to activate the electronic
ignition and light the pilot burner.
Hold the knob down for about 20 seconds before
releasing it. If the pilot flame goes out, repeat the
operation.
The pilot " ame can be seen through the peep hole
on the control panel.
MAIN BURNER IGNITION
Make sure the control knob is turned to "1".
Press and turn the knob from position " pilot on " to
position " max. flame " .
TURNING OFF
To switch the main burner off, turn the knob to
position " pilot on " .
To switch off the pilot flame, press and turn the
knob to position " Off " .
SWITCHING ON AND OFF
The energy regulator control knob has the following
positions:
OFF
MINIMUM POWER - HOLDING
INTERMEDIATE POWER - COOKING
MAXIMUM POWER
SWITCHING ON
Turn the energy regulator knob to any position
between "MIN" and "MAX".
The yellow indicator light switches on.
TURNING OFF
Turn the energy regulator knob to position " Off " .
The yellow indicator light switches off.
COOKING
Fill the well.
Turn the knob to position " 1 " .
Light the burners.
Adjust the heating accoding to your cooking
requirements.
When the chosen cooking position is other than "
MAX " , heating is intermittent. It switches on and
off automatically. The boiling intensity of the water
may vary visibly, but this has no effect on cooking.
When the heating switches off, the yellow
indicator light switches off too.
AT THE END OF SERVICE
Switch the heating off.
Switch the burners off.
Empty the well completely.
Turn the knob to position " 0 " .
12.

INDIRECT HEAT GAS BOILING PAN

The appliance is designed for cooking and
preparing food in water.
Do not light the pilot burner or leave it on when
there is no water in the well.
Do not activate the heating system when there is
no water in the well.
While the pasta cooker is on, the water level must
be maintained level with or above the minimum
level indicated on the rear wall of the well.
30