Instructions For Installation; Reminders For The Installer; Reference Standards And Laws; Unpacking - Modular 90/80 PGD100 Traduction Des Instructions D'origine

MANOMETER
The appliance is equipped with a manometer,
positioned on the control panel, which indicates
the steam pressure inside the jacket.
SAFETY VALVE
The appliance is equipped with an automatic safety
valve (H), positioned on the countertop, which
releases the steam contained in the jacket when
steam pressure approaches 50kPa (0,5 bar).
ANTI-DEPRESSION VALVE
The appliance is equipped with an automatic valve,
positioned on the countertop, which allows air to
enter the jacket when the appliance cools.
AUTOCLAVE PANS
STEAM DISCHARGHE VALVE
The appliance is equipped with an automatic safety
valve, built into the lid, which discharges steam
built up in the tank when steam pressure
approaches 0.05 Bar.
INSTRUCTIONS FOR
II.
INSTALLATION
3.

REMINDERS FOR THE INSTALLER

READ THIS MANUAL CAREFULLY. IT
PROVIDES IMPORTANT INFORMATION
FOR SAFE INSTALLATION, USE AND
MAINTENANCE OF THE APPLIANCE.
FAILURE TO COMPLY WITH WHAT IS
PRESENTED BELOW MAY COMPROMISE
THE SAFETY OF THE EQUIPMENT.
THE MANUFACTURER WILL NOT BE
LIABLE FOR ANY DAMAGE OR INJURY
RESULTING FROM FAILURE TO
OBSERVING THE FOLLOWING RULES.
Identify the specific appliance model. The model
number is detailed on the packing and on the
appliance dataplate.
The appliance must be installed in a well-ventilated
room.
Installation and conversion to a different type of
gas must be carried out by qualified technicians
authorized by the manufacturer, in compliance
with current safety standards and the instructions
in this manual.
Appliance maintenance and conversion to a
different type of gas must be carried out by
qualified technicians authorized by the
manufacturer, in compliance with current safety
standards and the instructions in this manual.
Do not obstruct any air vents or drains present on
the appliance.
Do not tamper with appliance components.
4.

REFERENCE STANDARDS AND LAWS

Install the appliance in accordance with the safety
standards in force in the country.
5.

UNPACKING

Check the state of the packing and in the event of
damage, ask the delivery person to inspect the
goods.
Remove the packing.
Remove the protective film from the outer panels.
Use a suitable solvent to remove any residual
adhesive from the panels.
6.

POSITIONING

The overall dimensions of the appliance and the
position of connections are given on the
installation diagram at the end of this manual.
The appliance can be installed singly or in
combination with other appliances in the same
product range.
The appliance is not suitable for integrated
installation.
Position the appliance at least 10 cm from adjacent
walls.
If the appliance is to be be placed near walls,
dividers, kitchen furniture, decorative elements
etc. this must be made of non-combustible
materials
Otherwise, they must be covered with suitable
non-combustible heat insulating materials.
Level the appliance by means of the height-
adjustable feet
25