Preparation - John Bean B 340 Manuel D'utilisation

1
50
5-9
5-10
5-11
Operation
5.4

Preparation

• The operator should be familiar with the warnings
and cautions
• The operator should be qualifi ed to work with the
machine.
• Alwaysensure that the wheel guard is lifted and the
gauge arm is in its home position (fully retracted).
5.4.1 Power up
• Do not keep any key pressed during power up.
Refer to (Fig. 5-9).
• Insert the power cable plug in the mains socket "1".
• Set the start switch to the "I" position.
Note: If the unit beeps and does not proceed or
if an error code is shown, refer to Chapter
( 7).
F
The unit will beep and perform a self-test now.
After switch on the fi rst screen page shown is INTRO
SCREEN (Fig. 5-10).
The unit is now ready for commands.
Note: From the INTRO SCREENpage, you
can switch directly to the RIM DATA
ENTRY screen page (Fig. 5-11) by simply
removing the detecting device for wheel
data acquisition.