Maintenance - Corghi BRC1T Manuel D'utilisation

Motor runs slowly
- A part is jammed or too tight. Check the roller (2 Fig. 7), the tube carrier (5 Fig. 7),
the motor (4 Fig. 7) and eliminate any problems.
Motor noisy and runs slowly.
- Defective relay; replace the relay board (see diagram) 1 fig.12.
Pushbutton faulty.
- Replace the board 1 fig.12.
One of the connectors on the board inside the cover panel (3 Fig. 7) is disconnected.
- Insert correctly (it can only be inserted in one way).
Sensor connector detached.
- Re-connect.
WARNING
Corghi declines all liability for claims derivin from the use of non-original spares or
accessories.
WARNING
Any procedure aimed at changing the pressure setting on the pressure relief device
is strictly prohibited.
The manufacturer declines any and all responsibility for damage caused by tampering
with these regulators.
WARNING
Before proceeding with any adjustment or maintenance work, disconnect the machine
from pneumatic and electric power supply, and check that all the moving parts are
locked in place.
ATTENTION
Do not remove or make changes to any part of this machine (only the assistance serv-
ice may do this).
- The regulator/lubricator filter is equipped with a semi-automatic condensate water drain.
This device is automatically activated whenever pneumatic supply to the machine is
cut off. Drain manually when the level of condensate is too high.
- From time to time, lubricate the spindle carrier arm on the rotation axis.
- On a regular basis, when the machine is at a standstill, remove the back panels and
remove the fluff that has collected there. Be careful not to pull out the electric wires.
Do not use compressed air to clean the machine, since this will spread the yarn fluff on
the mechanical moving parts and the electronic components.
User manual BR
The motor on one head fails to stop

MAINTENANCE

UK
41