Maintenance - Corghi PW IW 6 Manuel D'utilisation

CAUTION
The "Spare parts" handbook does not authorise the user to carry out work on the ma-
chine with the exception of those operations explicitly described in the User Manual.
It only enables the user to provide the technical assistance service with precise infor-
mation, to minimise delays.
CAUTION
Corghi declines all liability for claims derived from the use of non-original spare parts
or accessories.
CAUTION
Any procedure aimed at changing the pressure setting on the pressure relief device
is strictly prohibited.
The manufacturer declines any and all responsibility for damage caused by tampering
with these regulators.
CAUTION
Before proceeding with any adjustment or maintenance work, disconnect the machine
from pneumatic and electric power supply, and check that all the moving parts are
locked in place.
CAUTION
Do not remove or make changes to any part of this machine (only the assistance serv-
ice may do this).
- The regulator/lubricator filter is equipped with a semi-automatic condensate water drain.
This device is automatically activated whenever pneumatic supply to the machine is
cut off. Drain manually when the level of condensate is too high.
- On a regular basis, when the machine is at a standstill, remove the back panels and
remove the yarn fluff that has collected there. Be careful not to pull out the electric
wires. Do not use compressed air to clean the machine, since this will spread the yarn
fluff on the mechanical moving parts and the electronic components.
- Keep the oil level under control. If needed, only add CORGHI oil type Komol 22° or an
equivalent type after removing all accumulated yarn fluff from inside the head.
WARNING
Keep the work area clean.
Do not clean the machine with compressed air, jets of water or thinner.
When cleaning, take care not to create and raise dust as far as possible.
User manual PW IW 6" 8" 10"

maINTENaNCE

UK
37